Extron electronics SW HDMI Series User Manual page 16

Select the
Yes, this time only
•
connect to Windows Update only this one time.
Select
Yes, now and every time I connect a device
•
to automatically connect to Windows Update to search the web every time the
switcher is connected to this USB port.
Select
No, not this time
•
Windows Update to search the web at this time (for example, if the driver is
already on your computer).
3. Click . On the next screen, select the
Next
radio button, then click
(Recommended)
Figure 8. Selecting the Radio Button to Install the USB Driver
Automatically
Your computer locates the driver needed for it to communicate with the SW HDMI via
the USB port and loads it to the computer hard drive.
4. When the Completed screen appears, click
NOTE: This wizard appears only the first time you connect the SW HDMI to each
USB port. You do not see the wizard again unless you connect the switcher to
a different USB port on your computer.
5. Configure the switcher as desired using SIS commands (see the
Communication and Control
available commands).
radio button if you want your computer to
if you do not want the computer to connect to
Install the software automatically
(you do not need to insert a disc).
Next
to close the wizard.
Finish
section, beginning on page 21 for information on
SW HDMI Series • Installation
if you want the computer
Remote
10