Wall Mounting - ZyXEL Communications LTE3301-M209 User Manual

Table 2 Rear Panel Ports (continued)
LABEL
USIM/SIM Card Slot
Reset
WLAN
Power
DC Power In

1.8 Wall Mounting

You may need screw anchors if mounting on a concrete or brick wall.
Table 3 Wall Mounting Information
Distance between holes
M4 Screws
Screw anchors (optional)
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
3
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave
a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all
the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the Zyxel Device with the
4
connection cables.
Align the holes on the back of the Zyxel Device with the screws on the wall. Hang the Zyxel Device on
5
the screws.
Chapter 1 Introduction
DESCRIPTION
Insert your SIM card to the SIM card slot for the LTE network access.
Press the button to return the Zyxel Device to the factory defaults, if you forget your
password or cannot access the Web Configurator.
Press the WLAN button to turn on the WiFi.
Press the power button after the power cable is connected to start the device.
Use the power adapter provided with your Zyxel Device to connect an appropriate
power source to this socket.
11 cm
Two
Two
LTE3301-M209 User's Guide
17