Controls And Indicators - Graco Reactor E-10hp Instructions Manual

Controls and Indicators

Controls and Indicators
Key Name
Heater Controls
AA ISO Setpoint Increase
AB ISO Setpoint Decrease
AC RES Setpoint Increase
AD RES Setpoint Decrease
AE ISO Heater On/Off Key
AF RES Heater On/Off Key
AG Actual Temperature Key
AH Target Temperature Key
AJ Temperature Scale Key °F
AK Temperature Scale Key °C
AL Temperature Display
Heater Indicators
AM ISO Heater Activity
AN RES Heater Activity
AO Actual Temperatures Active
AP Target Temperatures Active
AR Fahrenheit Units Active
AS Celsius Units Active
System Controls
AT Heater Power
AU Motor Power
AV Motor Pump Control Function Knob Selects operation mode / pressure setpoint. See Motor/Pump Control
System Indicators
AW Boost Heat Indicator
AX Tank Level Indicator
AY System Status Indicator
14
Description
Increases the temperature setpoint by one degree in the units selected
within the setpoint limits. Press target key prior to adjusting.
Decreases the temperature setpoint by one degree in the units
selected within the setpoint limits. Press target key prior to adjusting.
Increases the temperature setpoint by one degree in the units selected
within the setpoint limits. Press target key prior to adjusting.
Decreases the temperature setpoint by one degree in the units
selected within the setpoint limits. Press target key prior to adjusting.
Turns heater on or off for ISO zone. Also clears heater zone diagnostic
codes, see page 32.
Turns heater on or off for RES zone. Also clears heater zone diagnostic
codes, see page 32.
Press to display actual temperature. Press and hold to display electrical
current.
Press to display target temperature. Press and hold to display heater
control circuit board temperature.
Press to change temperature scale to degrees Fahrenheit.
Press to change temperature scale to degrees Celsius.
Show actual temperature or target temperature of heater zones,
depending on selected mode. Defaults to actual at startup. Range is
32-170°F (0-77°C) for ISO and RES.
LEDs flash when heater zones are on. The duration
of each flash shows the extent that the heater is
turned on.
LEDs flash when heater zones are on. The duration
of each flash shows the extent that the heater is
turned on.
Actual temperatures are displayed.
Target temperatures are displayed.
Indicates that temperatures are displayed in °F.
Indicates that temperatures are displayed in °C.
Enables heater control. The switch includes a 20 A circuit breaker.
Enables motor. The switch includes a 20 A circuit breaker.
Function Knob, page 15.
Indicates boost heat is active.
See Tank Level Sensor LED, page 15.
Flashes an error code if alarm or deviation is active. See Motor/Pump
Status Codes, page 15.
332144E