Startup - Graco Reactor E-10hp Instructions Manual

Startup

Startup
Heated fluid can cause equipment surfaces to
become very hot. To avoid severe burns:
• Do not operate Reactor without all covers and
shrouds in place.
• Do not touch hot fluid or equipment.
• Allow equipment to cool completely before
touching it.
1. Perform Setup, page 16.
2. Set function knob to Slow Recirc
. See Heatup Guidelines, page 21, then con-
tinue with steps 3-6.
2
3
1
4
0
5
6
+
7
8 OR
-
9
10
3. Turn on Heater Power.
4. Set temperatures:
°
a. Press or
scale.
b. Press to display target temperatures.
c. To set heat zone target temperature,
press or
desired temperature. Repeat for
20
or Fast Recirc
2
3
1
4
0
5
6
+
7
8
-
9
10
ti21489a
°
to change temperature
until display shows
zone.
d. Press to display actual temperatures.
5. Circulate through heater until temperature readouts
display desired temperature. See Table 6.
6. Adjust heat controls as necessary for a stable spray
temperature.
Table 6: Approximate heatup time for starting a cold
machine with 5 gallons (19 liters) per side
Fluid Spray Target
Temperature
125°F (52°C)
170°F (77°C)
NOTE: Heatup times are based on 70°F (21°C) starting
material temperature and 70°F (21°C) ambient tempera-
ture.
NOTE: Different fluids will absorb heat at different rates.
When refilling a warm machine, heatup times will be
less.
120VAC 230VAC
35 ft (10.7 m) Hose
(1 bundle)
15 minutes 10 minutes
40 minutes 20 minutes
332144E