Disassembly Of The Pvc Protective Plates For Service Tasks From The Bottom; Water Connection; Operation With External Water Supply - Kärcher HDS 9/50 De Tr1 Service Manual

10.9 Disassembly of the PVC protective plates for service tasks from the bottom

For service tasks from the bottom, the two PVC protective
plates must be dismantled.
NOTE
For the oil change of the motor it is enough to remove the
left PVC plate.

10.10 Water connection

For connection values refer to technical specifications

10.10.1 Operation with external water supply

For the disassembly of the booster heater, it is enough to
remove the right PVC plate.
For tasks on the heat exchanger as well as for draining the
coolant, both PVC plates must be removed.
1 Screw
 Unscrew the 3 screws for the fastening of the PVC
plates on the frame.
 Carefully pull out the PVC plate.
NOTE
Pay attention to how the PVC plate above the black plate
in the centre of the vehicle is inserted, so that it can be re-
installed correctly.
Dismantled PVC plate.
 Close stop cock water tanks.
 Uncoil the water hose from the hose reel and connect it
to the water supply (e.g. tap).
 Open the water supply.
The float valves in the supply regulate the filling level in
the float container.
English 5.906-736.0 Rev. 00 (07/15)
93