166
English 5.906-736.0 Rev. 00 (07/15)
Unscrew the screw of the front rubber buffer support.
NOTE
The structure with the 350/500 bar pumps is similar.
1 Drive shaft
Remove the pump with the intermediate gear from the
drive shaft.
NOTE
If necessary, support by levering out in the recesses on the
flange area of the motor plate.
1 Drive shaft
2 Claw clutch
3 Elastomer ring
4 Flange plate
If necessary, exchange the elastomer ring. For this pur-
pose, pull out the drive shaft and replace the elastomer
ring.
NOTE
If the entire claw coupling must be replaced, the coupling
halves of the drive shaft and the flange plate must be un-
screwed.
In order to unscrew the coupling half from the flange plate,
it must be unscrewed from the motor first.
NOTE
Properly grease the drive shaft prior to installation!
In order to do so, use the lubricating and installation paste,
part number 6.869-088.0!