Clean / change the reed switch for flow monitoring
Clean magnetic pen
136
English 5.906-736.0 Rev. 00 (07/15)
Disconnect the high-pressure outlet to the booster
heater.
Unscrew the screw for fastening the safety block form
the console, remove the block.
NOTE
Observe the installation position of the reed switch on the
casing:
The marking on the reed switch points centrally to the casing!
1 Reed switch
2 Clips
Open clips, pull out the reed switch for flow monitoring.
Clean reed switch; change in case of a defect.
Observe the cable run when changing the switch!