1 Valve body
2 Tappet with hexagon nut
3 Magnet coil
Open the hexagon nut on the tappet.
Pull the tappet out of the valve body.
Clean the valve body.
Clean the tappet with a soft cloth if necessary.
NOTE
When changing the complete solenoid valve, the hoses
must be disconnected and the valve must be unscrewed
from the bottom. Finally electrically disconnect the valve.
Observe the cable run with the electrical connection!
Mind the flow direction of the solenoid valve (arrow)!
172
English 5.906-736.0 Rev. 00 (07/15)