Messages - Panasonic VDR-D300 Operating Manual (English, Spanish) Operating Instructions Manual

Messages

CANNOT RECORD.
NO DATA.
THIS DISC IS
INCOMPATIBLE.
PLEASE CHECK THE
DISC.
RECOMMENDED TO USE
PANASONIC DISC
AGS MODE ON -REC
PAUSED
CANNOT RECORD.
(THIS DISC IS FINALIZED)
CANNOT RECORD. DISC
IS FULL.
CANNOT RECORD. THE
NUMBER OF SCENES HAS
EXCEEDED THE MAXIMUM
LIMIT.
CANNOT OPERATE.
TEMPERATURE IS HIGH.
PLEASE TURN OFF AND
WAIT A WHILE.
CANNOT UN-FINALIZE
THIS DISC.
CHECK CARD.
CARD LOCKED.
Data writing to the disc or card has failed.
There are no images recorded on the disc or card.
You inserted an incompatible disc (copy-protected discs, etc.).
You inserted a disc that cannot be read on this unit (a disc
recorded in PAL video format etc.).
You inserted a disc that does not meet the DVD standard for
quality and performance so you may not be able to record
normally. Refer to the following support site for information
about discs that have been confirmed as compatible by
Panasonic.
http://panasonic.co.jp/pavc/global/cs/e_cam
(This website is in English only.)
The AGS function is activated. (l 49)
A finalized DVD-RW (Video format) or DVD-R has been
inserted. After finalizing, the discs become play-only and cannot
record. If you un-finalize a DVD-RW (Video format), it can be
used for recording. (l 101)
The disc is full or the number of scenes has reached the
maximum limit so no further data can be recorded. Delete
unnecessary scenes (l 81) or insert a new disc.
The temperature of the unit is high so it cannot be operated.
Turn off the power, wait until the unit cools and then turn on the
power again.
DVD-R cannot be un-finalized.
DVD-RW (VR format) cannot be un-finalized. DVD-RW (VR
format) after finalization can be recorded and edited in the same
way as DVD-RW (VR format) before finalization.
This card is not compatible or it cannot be recognized by the
unit.
The write protection switch on the SD Memory Card is set to
LOCK. (l 26)
Indications
147
LSQT1011