Panasonic VDR-D300 Operating Manual (English, Spanish) Operating Instructions Manual page 110

With a printer (PictBridge)
6 Select the date print setting on [
≥ If the printer is not capable of date printing, this setting is unavailable.
7 Select the paper size setting on [
STANDARD: Size specific to the printer
4t5 INCH:
5t7 INCH:
4t6 INCH:
A4:
≥ You cannot set paper sizes not supported on the printer.
8 Select the layout setting on [
STANDARD: Layout specific to the printer
:
:
≥ You cannot set page layouts not supported on the printer.
9 Select [
The pictures are printed.
≥ Exit PictBridge by disconnecting the USB cable (supplied) after the
pictures have been printed.
When you stop printing halfway
Move the joystick down.
A confirmation message appears. If [YES] is selected, the number of prints set is canceled and the
screen returns to step 3. If [NO] is selected, all the settings are kept and the screen returns to
step 3.
≥ Avoid the following operations during printing.
These operations disable proper printing.
– Disconnecting the USB cable
– Removing the SD card
– Switching the mode dial
– Turning off the power
≥ Check the settings for the paper size, quality of
print, etc. on the printer.
≥ The sides of pictures recorded when [
(VDR-D300)/[
at printing. Check before printing.
When using the printer with a trimming feature or
other feature which cuts out both edges of the
pictures, cancel the feature for printing. (Refer to the
operating instructions of the printer for details.)
110
LSQT1011
L size
2L size
Postcard size
A4 size
No frame print
Frame print
PRINT] # [YES] and press the joystick.
2
] (VDR-D250) is set may be cut
1.7
DATE PRINT].
PAPER SIZE].
PAGE LAYOUT].
≥ You may not be able to print still pictures recorded
with other products.
≥ When the unit is connected directly to the printer,
the DPOF settings cannot be used.
≥ Connect the printer directly to this unit. Do not use a
USB hub.
]