Setting Date And Time - Panasonic SD/HDD SDR-H20 Operating Instructions Manual

Setup
2
Select a menu item.
≥ Use the direction buttons (3,4,2,1) and
ENTER button in place of the joystick on the
main unit.
3
Press the MENU button to exit
the menu screen.

Setting date and time

When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥ Select [YES] and press the joystick. Perform
steps 2 and 3 below to set the date and time.
If the screen shows the incorrect date and time,
then adjust it.
¬ Rotate the mode dial to select
.
1
Press the MENU button, then
select [BASIC] # [CLOCK SET]
# [YES] and press the joystick.
36
LSQT1190
MENU
ENTER
MENU
ENTER
or
MENU
2
Move the joystick left or right to
select the item to be set. Then,
move the joystick up or down to
set the desired value.
≥ The year will change as follows:
2000, 2001, ..., 2099, 2000, ...
≥ The 12-hour system is used to display the time.
3
Press the joystick to enter the
selection.
≥ The clock function starts at [00] seconds when
the joystick is pressed.
≥ After pressing the MENU button to finish the
setting, check the date and time display.
∫ Changing the date and time
display style
Press the MENU button, then select
[SETUP] # [DATE/TIME] # desired
display style and press the joystick.
≥ You can also show or change the date and
time display by repeatedly pressing the DATE/
TIME button on the remote control.
(SDR-H200)
[DATE]
DEC.15.2007
[OFF]
∫ Changing the display style
Press the MENU button, then select
[SETUP] # [DATE FORMAT] #
desired display style and press the
joystick.
[D/T]
DEC.15.2007 3:30 PM