Setting Date And Time - Panasonic SDR-H250EP Operating Instructions Manual

LSQT1210_EP(EN).book 30 ページ ２００７年２月９日 金曜日 午後６時０分
Setup
2
Select a menu item.
ENTER
≥ Use the direction buttons (3,4,2,1) and
ENTER button in place of the joystick on the
main unit.
3
Press the MENU button to exit
the menu screen.
ENTER

Setting date and time

When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥ Select [YES] and press the joystick. Perform
steps 2 and 3 below to set the date and time.
If the screen shows the incorrect date and time,
then adjust it.
¬ Rotate the mode dial to select
.
1
Press the MENU button, then
select [BASIC] # [CLOCK SET]
# [YES] and press the joystick.
30
LSQT1210
2
MENU
≥ The year will change as follows:
≥ The 24-hour system is used to display the time.
3
MENU
≥ The clock function starts at [00] seconds when
≥ After pressing the MENU button to finish the
∫ Changing the date and time
Press the MENU button, then select
[SETUP] # [DATE/TIME] # desired
display style and press the joystick.
≥ You can also show or change the date and
[DATE]
or
[OFF]
∫ Changing the display style
MENU
Press the MENU button, then select
[SETUP] # [DATE FORMAT] #
desired display style and press the
joystick.
Move the joystick left or right to
select the item to be set. Then,
move the joystick up or down to
set the desired value.
2000, 2001, ..., 2099, 2000, ...
Press the joystick to enter the
selection.
the joystick is pressed.
setting, check the date and time display.
display style
time display by repeatedly pressing the DATE/
TIME button on the remote control.
(SDR-H250)
[D/T]
15.12.2007 15.12.2007 15:30