Setting Interface Control - Avaya 9601 Installing And Maintaining

• Audio Opt
• HAC Opt
3. Press Save.
Related links
Administering audio equalization

Setting interface control

About this task
Use the following procedure to set or change the interface control value.
Procedure
1. Use the Craft password to gain access to the Admin Procedures screen. The default
password is 27238.
2. When you select INT... from the Admin Procedures screen, the following text displays with a
prompt to use the Right and Left navigation arrows to select a setting:
Ethernet: Choice Selector
PC Ethernet: Choice Selector
The values shown are the text strings associated with the current PHY1STAT on the
Ethernet line and the current PHY2STAT system value on the PC Ethernet line. The
PHY1STAT text strings are:
• "Auto" when PHY1STAT = 1
• "10Mbps half" when PHY1STAT = 2
• "10Mbps full" when PHY1STAT = 3
• "100Mbps half" when PHY1STAT = 4
• "100Mbps full" when PHY1STAT = 5
• "1000Mbps full" when PHY1STAT = 6
Note:
A PHY1STAT value of 6 applies only to deskphone models that support Gigabit Ethernet
(GigE), otherwise this value/choice does not display.
The PHY2STAT text strings are:
• "Disabled" when PHY2STAT = 0
• "Auto" when PHY2STAT = 1
• "10Mbps half" when PHY2STAT = 2
• "10Mbps full" when PHY2STAT = 3
• "100Mbps half" when PHY2STAT = 4
August 2016 Installing and Maintaining Avaya 9601/9608/9608G/9611G/9621G/9641G/9641GS IP
on page 38
Deskphones SIP
Comments on this document? infodev@avaya.com
Administration through the deskphone
39