Fatal Errors; Laser Failure - Xerox phaser 6250 Service Manual

Fatal Errors

Laser Failure

Code 07:
Laser power has failed
Code 08:
SOS (start of scan) failure 1
Code 09:
SOS failure 2
Code 10: Warm up failure
Code 11:
This is the generic laser fault used by the engine if a lower level error
cannot be reported to the controller.
Troubleshooting Reference Table
Applicable Parts
Laser Unit, PL 9.1.1
Troubleshooting Procedure Table
Steps Actions and Questions
1 Check and reseat P/J151 on the Laser
Unit.
Does the printer function correctly if the
harness is reseated?
2
Replace the Laser Unit.
Does the error recur after the Laser Unit
has been replaced?
3 Check the Laser Harness for continuity or
damage.
See the wiring diagram "Laser Unit" on
page 10-22.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Laser Unit" on page 10-22
manuals4you.com manuals4you.com
Yes
Complete
Go to Step 3.
Replace the
(ROSKA) Harness
Assembly,
PL 13.1.5.
No
Go to Step 2.
Complete
Replace the
Engine Control
Board,
page 8-107.
3-63