Xerox phaser 6250 Service Manual page 95

Test
OHP Sensor
Fuser Center
Temp Sensor
Fuser Edge
Temp Sensor
Fuser Center
Temp Amplifier
Fuser Temp
Compensation
Clutch Tests - Tests the functionality of the clutches by giving service personnel the ability to
energize/de-energize one clutch at a time.
Registration
Clutch
Tray 1 (MPT)
Turn Clutch
Tray 2 Turn
Clutch
Tray 3 Turn
Clutch
Tray 4 Turn
Clutch
Solenoid Tests - Tests the functionality of the clutches by giving service personnel the ability
to energize/de-energize one solenoid at a time.
3-14
Front Panel Display and Test Definition
OHP
Absence of Media
Paper
<Fuser Center Temp Sensor>
Fuser (Not) Ready
Sensor (Failure) is OK
<Fuser Edge Temp Sensor>
Fuser (Not) Ready
Sensor (Failure) is OK
<Fuser Center Temp Amplifier>
Fuser (Not) Ready
Temperature Amplifier (Failure) is
OK
<Fuser Temp Compensation>
Fuser (Not) Ready
Compensation (Failure) is OK
Clutch is: ON
Clutch is: OFF
Phaser 6250 Color Laser Printer Service Manual
Reports "Paper" if opaque media is
present.
Reports "OHP or Absence of
Media if OHP or no media is
present.
Manually insert a sheet of paper
backwards through the
Registration Chute Assembly
(PL9.1.6) until the state of the
sensor changes to "Paper".
Remove fuser to change sensor
state.
Remove fuser to change sensor
state.
Remove fuser to change sensor
state.
Remove fuser to change sensor
state.
Audible verification of Clutch
functionality. You should hear the
clutch engage and disengage
(click) on and off continuously until
test is ended by pressing Cancel.