Xerox phaser 6250 Service Manual page 108

Troubleshooting Procedure Table (Continued)
Steps Actions and Questions
16 Perform Steps 1 through 3 on page 8-19.
Open and close the front door.
Observe the Turn Roller.
Does the Turn Roller turn while the
machine is warming up?
17 Using service diagnostics, test the Tray 1
Turn Clutch.
Does the Turn Clutch Assembly function
normally?
In the test, actuate the Interlock switch.
18 Remove the clutch connector J19.
Check the following pins;
Is J19-1 <=> J19-2 less than 200Ω?
19 Does the Feed Gear in Tray 1 turn when
printing 1 sheet of paper?
20
Use service diagnostics to test the Tray 1
Feed Solenoid.
Does the solenoid actuate?
In the test, actuate the Interlock Switch.
21 Remove the Tray 1 Feed Solenoid
connector J132;
Is J132-1 <=> J132-2 less than 100Ω?
22 Check the Front 2 Harness for continuity. Replace the
Error Messages and Codes
Yes
Go to Step 19.
Check the Clutch
for slip or the gear
for damage.
Replace if
necessary.
Replace the
Engine Control
Board, page 8-107.
Check parts for
damage or
obstructions in the
paper path.
Check the spring
and stopper of the
Feed Solenoid.
Go to Step 22.
Engine Control
Board, page 8-107.
manuals4you.com manuals4you.com
No
Go to Step 17.
Go to Step 18.
Replace the
MPT Turn
Clutch,
page 8-34.
Go to Step 20.
Go to Step 21.
Replace the Tray
1 Feed Solenoid.
Replace Front 2
Harness
Assembly, PL
6.1.2.
3-27