Wrong Paper Type; Load Tray [1 (Mpt)] [2] [3] [4] With [Size] [Type] - Xerox phaser 6250 Service Manual

Wrong Paper Type; Load Tray [1 (MPT)] [2] [3] [4] with
[size] [type]
■
Remove tray and inspect the tray cavity of the printer to ensure that it is free
of obstructions or debris.
■
Ensure that the tray is loaded with supported media.
■
Reinstall the tray.
■
Cycle printer power.
■
If the problem persists, follow the procedure below
Note
This is a media TYPE mismatch error indicating an OHP Sensor malfunction.
Troubleshooting Reference Table
Applicable Parts
OHP Sensor Kit PL 9.1.12
Troubleshooting Procedure Table
Steps Actions and Questions
1 Check the following for evidence of fault or
damage:
OHP Sensor and Harness PL 9.1.12
Chute Assembly Registration PL 9.1.6
Replace parts as required .
2 Does printer function correctly?
3 Using service diagnostics, test the OHP
Sensor.
Does the OHP Sensor function correctly?
4 Does printer function correctly?
5 Check voltage between P/J32-2 <=> P/J
32-1 on Engine Control Board is 0VDC.
6 Block the OHP Sensor. Has P/J32-2 <=> P/
J32-1 changed from 0 VDC to +3.3 VDC?
7
Does printer function correctly?
8 Verify the voltage between P/J32-3 <=> P/
J32-1 on the Engine Control Board is
+5 VDC.
3-62
Wiring and Plug/Jack Map References
"Paper Feed" on page 10-25
Phaser 6250 Color Laser Printer Service Manual
Yes
OHP Sensor and
Harness page 8-75.
Assembly, Chute
Registration
page 8-71
Complete
Replace Engine
Control Board,
page 8-107.
Complete
Go to Step 6.
Replace Engine
Control Board,
page 8-107.
Complete
Replace the OHP
Sensor, page 8-75.
No
Go to Step 3.
Go to Step 3.
Go to Step 5.
Go to Step 5.
Go to Step 8.
Go to Step 8.
Go to Step 8.
Replace Engine
Control Board,
page 8-107.