Connecting external units (continued)
When connecting the unit to an Apple Macintosh computer
•
Connect the 1394 cable after turning on the power of the Apple Macintosh computer. Otherwise, the unit
may not be mounted.
•
The unit may not be recognized after the Apple Macintosh computer has been placed in the hibernation
state by its power-saving setting. In this case, disconnect the 1394 cable and then re-connect it.
If the unit is not mounted properly on an Apple Macintosh computer
•
When the P2 card access lamp flashes orange
1. Select [Applications] " [Utilities] " and start up [Disc Utility].
2. Select a grayed-out volume among volumes of the X.X GB Panasonic disc, and click "Mount."
•
When the P2 card access lamp is off
Eject the P2 card, and insert it again. If the unit is still not mounted, disconnect the 1394 cable and then
re-connect it.
Hard disk drive (data copying)
Hard disk drive
•
Before proceeding to connect or disconnect 1394 cable, be absolutely sure to turn off the power of the
units.
•
Before proceeding to connect the unit which uses a 6-pin type 1394
connector, carefully check the shape of the 1394 cable and the connectors
on the 1394 cable. Connecting a connector upside down may damage the
parts inside the unit and cause malfunctioning. The above also applies to
USB cable as well.
•
When connecting to a device having 4-pin type 1394 connector, first
connect the cable to the 6-pin type 1394 connector on the camera.
•
Do not apply force when connecting 1394 cable to 1394 connector as this
may damage the connector.
78
Ferrite core (included)
19 cable (optional)
1394
-pin
-pin type
-pin type
-pin type
-pin type