Hard Disk Drive (Data Copying) - Panasonic SD AG-HPX171E Operating Instructions Manual

When connecting the unit to an Apple Macintosh computer
• Connect the 1394 cable after turning on the power of the Apple Macintosh computer. Otherwise, the unit
may not be mounted.
• The unit may not be recognized after the Apple Macintosh computer has been placed in the hibernation
state by its power-saving setting. In this case, disconnect the 1394 cable and then re-connect it.
If the unit is not mounted properly on an Apple Macintosh computer
• When the P2 card access lamp flashes orange
1. Select [Applications] " [Utilities] " and start up [Disc Utility].
2. Select a grayed-out volume among volumes of the X.X GB Panasonic disc, and click "Mount."
• When the P2 card access lamp is off
Eject the P2 card, and insert it again. If the unit is still not mounted, disconnect the 1394 cable and then
re-connect it.

Hard disk drive (data copying)

Hard disk drive
Ferrite core (included)
• Before proceeding to connect or disconnect 1394 cable, be absolutely sure to turn off the power of the
units.
• Before proceeding to connect the unit which uses a 6-pin type 1394
connector, carefully check the shape of the 1394 cable and the connectors
on the 1394 cable. Connecting a connector upside down may damage the
parts inside the unit and cause malfunctioning. The above also applies to
USB cable as well.
• When connecting to a device having 4-pin type 1394 connector, first
connect the cable to the 6-pin type 1394 connector on the camera.
• Do not apply force when connecting 1394 cable to 1394 connector as this
may damage the connector.
1394
6-pin
139 cable (optional)
ENGLISH
6-pin type 6-pin type -pin type -pin type
E-79