Porsche Boxster Technical Manual page 168

55
Lids, flaps
Boxster
Disassembling and assembling front lid
Note:
No.
Designation
Qty.
Removal Installation
1
Lid 1
2 Rubber buffer 2
Remove rubber buffers by
turning them.
Adjust lid to the hinges in
accordance with the con-
tours of the wings and
the front spoiler.
Screw in rubber buffers.
Combination screw M6 x 12 2
3
4 Upper part of lock 1 Remove upper part of lock
from lid.
10 5
Combination screw M6 x 14
6
Hinge left
1
Loosen fastening screws
and remove lid from vehicle.
Loosen combination screws
M6 x 14
Loosen combination screws
M6 x 14
7
Hinge right
1
8
1
Plug connection
Disconnect cable-harness
plug connection.
Press Bowden cable out of
holder.
9
Bowden cable
1
10
Lower part of lock
1
Tightening torque
10 Nm (7.5 ftlb.)
Fasten upper part of lock
with the combination
screws to the lid and ad-
just to the lower part of
the lock.
Lay lid on hinges and
screw tight.
Adjust to left side part ac-
cording to lid contour.
Adjust to right side part
according to lid contour.
Insert cable-harness plug
connection.
Press Bowden cable into
holder.
Fasten lock lower part
with combination screws
and adjust to lock upper
part.
Combination screw M6 x 30
1
Undo
11
55-3
55 22 37 Disassembling and assembli"l~ front lid
Printed in Germany -10, 1997 986551