Porsche Boxster Technical Manual page 161

Boxster (986)
Body rear
2
Cleaning the welding areas
3
4
Inserting inner wheel housing/inner side
member into the body
Inserting the spare parts into the body
Remove the factory-applied primer on the welding areas of
the spare parts -A, B, C, D, E, F, G, H, I, J, K, L, M-
using the rotary brush.
Drill or punch (with a hole punch) .07 mm holes spaced
20mm apart for plug-welding with shielding gas.
~ 53-19 page 8
Remove underbody coating and paint layers, etc. from the
welding areas of the body with a hot-air gun or rotary
brush.
Fasten spare inner wheel housing and inner side member
onto the straightening attachment.
Fit the spare outer side member, inner side section, outer
wheel housing and the closing part.
536855 Replacing rear wheel housing
Printed in Germany -43, 2001
53-19 page 7
a5368551