Porsche Boxster Technical Manual page 143

Boxster (986)
Body rear
No.
Procedure
Instructions
Cleaning the welding areas Remove underbody coating and paint layers, etc. from the
welding areas of the body with a hot-air gun or rotary
brush.
Preparing spare parts Remove the factory-applied primer on the welding areas of
the spare parts -A, C, D, E, F- using the rotary brush.
Inserting the end cross member in the body Insert the trunk floor panel spare part overlapping the side
member and the protruding trunk floor panel and fit into
place.
Insert the end cross member and fit into the side sections
left and right. Install the rear lid, adjusting the contours and
gap dimensions at the left and right in relation to the side
sections. => Rep. Gr. 5; Body gap dimensions
Install the lower part of the lid lock at the
rear,=> Rep. Gr. 558619; Removing and installing lower
part of lid lock and check whether the upper part of the
lock engages in the lower part of the lock.
2
3
532455 Replacing rear trunk floor panel
Printed in Germany -37,2000
53-17 page 5
a532455x