BMW HP4 Rider's Manual page 80

Adjusting display setting
6
78
To change display setting in
LAPTIMER mode, press but-
ton 2 repeatedly until display
has desired appearance.
z
Starting time recording
Press button 1 to start record-
ing.
For the headlight flasher
signal to be detected, the
engine must be running.
When driving over Start/Finish
line, press button 1 again to
start recording for next race
lap.
The data of the preceding race
lap will be saved.
If the display mode is exited
during a recording, then the
recording continues to run.
However, the recording of a
new lap can only be started in
the other modes with an exter-
nal signal.
Infrared receiver
with infrared receiver
Operation of the instrument clus-
ter in the LAPTIMER mode can
be carried out conveniently with
an infrared signal. For this pur-
pose, the infrared receiver avail-
able as an optional accessory
must be connected. Operation
with the headlight flasher but-
ton is also possible with the inte-
grated infrared receiver.
To avoid the premature detection
of a completed lap due to inter-
ference signals, a minimum lap
time can be specified (
Signals received before this time
expires are then ignored.
OA
94).