BMW HP4 Rider's Manual page 101

Adjust damping as desired us-
ing buttons 1 and 2.
+1 to +7: Damping increase in
maximum of seven steps.
-1 to -7: Damping decrease in
maximum of seven steps.
0: Basic setting.
Performing zero position
alignment
Place motorcycle on side stand
or a suitable auxiliary stand.
During the alignment, do not sit
on the motorcycle and remove
any cargo or luggage.
In order to adjust the zero po-
sition, press buttons 1 respec-
tively 2, until position 3 shows
"DDC" and position 4 shows
"CAL" (calibration).
Next, press and hold button 2,
until lettering "CAL" starts
flashing.
If zero position adjustment was
successful, a check mark is
shown.
If the check mark is not shown:
Repeat alignment.
If the check mark is not shown
after repeated alignment at-
tempts, consult a specialized
workshop, preferably an autho-
rized BMW Motorrad retailer.
Installing plug connector
for a leveling sensor
Remove fairing side panel
( 135).
6
99
z