Table of Contents
Advertisement
Periodic maintenance and adjustment
3.
Loosen the quick fastener screws.
1. Quick fastener screw
2. Top cover
4.
Lift up the rear of the top cover, discon-
nect the main switch coupler and the aux-
iliary DC jack coupler, and then remove
the cover.
1. Top cover
2. Main switch coupler
2
1. Top cover
2. Auxiliary DC jack coupler
52
To install the top cover
1.
Connect the main switch coupler and
auxiliary DC jack coupler.
2.
Place the top cover in the original posi-
tion, making sure to fit the projections on
the cover into the slots in the headlight
unit.
1
1. Top cover
1
3.
Tighten the quick fastener screws.
4.
Pass the brake hose, throttle cable, park-
ing brake cable and wire harness through
the cable guide, place the cable guide in
the original position, and then install the
screws.
2
1
1. Cable guide
5.
Install the left side cover and the shroud.
ECS00372
NOTICE
Make sure that all cables, hoses and
G
leads are routed properly before install-
ing the shroud and covers.
1
Advertisement
Table of Contents
