Driving - Yamaha RX10PB Owner's Manual

Operation
around the already weakened area. To mini-
mize possible damage, consult your stud
manufacturer for installation and stud pattern
recommendations.
Yamaha does not recommend track stud-
ding.
ESU11395

Driving

EWS00300
WARNING
Be sure to read the "SAFETY INFORMA-
TION" section on page 6 and the "Riding
your snowmobile" section on page 39
carefully before operating the snowmo-
bile.
EWS00310
WARNING
Make sure that the throttle lever is fully
G
released and the snowmobile is at a full
stop before shifting.
Be sure to slide the shift lever to "FWD"
G
or "REV" until it stops completely and
only while the engine is idling.
Make sure that the area behind the
G
snowmobile is clear before reversing.
Watch behind.
Reduce speed and avoid sharp turning
G
when operating the snowmobile in re-
verse.
TIP
Make sure that the engine is warmed up
enough before riding.
1. To select the desired operating position,
pull the shift lever out, slide it to "FWD" or
to "REV" until it stops, and then release it.
NOTICE: Do not shift from "FWD" to
"REV" or from "REV" to "FWD" while
the snowmobile is moving, as the
drive train could be damaged.
44
1. Pull out.
2. Slide to "FWD" (forward).
3. Release.
1. Pull out.
2. Slide to "REV" (reverse).
3. Release.
TIP
The reverse buzzer beeps while the shift lever
is in reverse.
2. While squeezing the brake lever, release
the parking brake by moving the parking
brake lever to the right, and then release
the brake lever.
[ECS00811]
1
3
2
3
1
2