Replacing A Fuse - Yamaha RX10PB Owner's Manual

INTERNAL: Drink large quantities of wa-
G
ter or milk. Follow with milk of magne-
sia, beaten egg, or vegetable oil. Call
physician immediately.
EYES: Flush with water for 15 minutes
G
and get prompt medical attention.
Batteries produce explosive gases. Keep
sparks, flame, cigarettes, etc. away. Venti-
late when charging or using in an en-
closed space. Always shield your eyes
when working near batteries.
KEEP OUT OF THE REACH OF CHILDREN.
Charge or have a Yamaha dealer charge the
battery as soon as possible if it seems to have
discharged. Keep in mind that the battery
tends to discharge more quickly if the snow-
mobile is equipped with electrical accesso-
ries.
EWS00610
WARNING
Never smoke around the battery while it
G
is being charged. Sparks may ignite the
hydrogen gas created by the battery.
Disconnect the negative lead first, then
G
the positive lead from the battery.
Connect the positive lead first, then the
G
negative lead to the battery when install-
ing the battery.
Never connect the battery to or discon-
G
nect it from the snowmobile while it is
being charged. Sparks may ignite the
hydrogen gas created by the battery.
Make sure that the battery terminals are
G
tight.
ECS00843
NOTICE
To charge a VRLA (Valve Regulated
G
Lead Acid) battery, a special (constant-
voltage) battery charger is required. Us-
ing a conventional battery charger will
damage the battery.
Periodic maintenance and adjustment
Do not charge the battery quickly.
G
ESU12338

Replacing a fuse

EWS00550
WARNING
Be sure to use the specified fuse. A wrong
fuse could cause electrical system dam-
age or A FIRE HAZARD.
ECS00631
NOTICE
Be sure to turn the main switch to the off
position and disconnect the negative bat-
tery lead to prevent accidental short-cir-
cuiting.
The main fuse, the EPS fuse, and the fuel in-
jection system fuse are located under the air
filter case. The fuse box, which contains the
fuses for the individual circuits, is located be-
hind the right side cover.
1. Remove the shroud, the left and right
side covers, and the top cover. (See page
50 for removal procedures.)
2. Remove the headlight unit. (See page
76.)
3. Loosen the joint clamp bolts.
1
1. Joint clamp bolt
4. Unhook the air filter case fastener and
disconnect the air temperature sensor
coupler.
79