Drive Guard - Yamaha RX10PB Owner's Manual

1
2
1. Pull out.
2. Slide to "FWD" (forward).
3. Release.
3
1. Pull out.
2. Slide to "REV" (reverse).
3. Release.
ECS00072
NOTICE
Do not use the shift lever while the snow-
mobile is moving, otherwise the drive train
could be damaged.
ESU13314

Drive guard

EWS00402
WARNING
Coming in contact with the rotating V-
G
belt or clutch parts can cause severe in-
jury or death. Never run the engine with
the drive guard removed.
Make sure that the drive guard is in-
G
stalled securely before operating the
snowmobile to protect against severe
3
1
2
Control functions
injury or death from a broken V-belt or
other part should it come off the snow-
mobile while it is in operation.
ECS00930
NOTICE
Never run the engine with the V-belt re-
G
moved. Clutch components can be dam-
aged.
Be careful not to scratch the windshield
G
when removing or installing the drive
guard.
The drive guard is designed to protect the V-
belt clutch and V-belt in case parts break or
come loose.
The drive guard is located behind the left side
cover. (See page 50 for removal procedures.)
To remove the drive guard
1. Pull out the drive guard locking pin from
the drive guard rear holder.
1. Drive guard
2. Drive guard locking pin
2. Lift up the rear of the drive guard as
shown, and then pull the guard rearward
to remove it.
2
1
23