Electric Power Steering Warning Indicator "Eps; Self-Diagnosis Device; Engine Stop Switch - Yamaha RX10PB Owner's Manual

down, and then check the coolant level in the
coolant reservoir. (See page 61 for checking
procedures.)
1. Coolant temperature warning indicator "
2. Warning light "
ECS00041
NOTICE
Do not continue to operate the engine if it
is overheating.
ESU13812
Electric power steering warning
indicator "EPS"
The electric power steering warning indicator
comes on when the key is turned to the on po-
sition, and then goes off once the engine is
started. If the warning indicator remains on or
comes on after the engine is started, the EPS
system may not be working correctly. When
this occurs, have a Yamaha dealer check the
EPS system.
1. Electric power steering warning indicator
"EPS"
"
Control functions
TIP
If the steering load is too heavy (i.e., exces-
sive steering use when the snowmobile is
traveling at a slow speed), the power assist is
reduced to protect the EPS motor from over-
heating.
ESU13365

Self-diagnosis device

This model is equipped with a self-diagnosis
device for various electrical circuits.
If a problem is detected in any of those cir-
cuits, the warning light and the engine trouble
warning indicator flash, and an error code dis-
"
plays in the meter display. Note the error
code, and then have a Yamaha dealer inspect
the snowmobile as soon as possible.
NOTICE: Do not continue to operate the
engine longer than necessary if there is an
error code to avoid possible engine dam-
age.
[ECS00820]
1. Warning light "
2. Engine trouble warning indicator "
3. Error code display
ESU10531

Engine stop switch " "

The engine stop switch is used to stop the en-
gine in an emergency. Simply push the stop
switch to stop the engine. To start the engine,
pull the stop switch and proceed with starting
the engine. (See page 38 for engine starting
procedures.)
2 3
"
1
"
19