Table of Contents
Advertisement
Periodic maintenance and adjustment
1. Spring scale
TIP
Measure the gap between the slide runner
and the edge of the track window on both
sides.
1. Drive track deflection
2. Slide runner
Standard drive track deflection:
30.0–35.0 mm (1.18–1.38 in)
3.
If the deflection is incorrect, adjust the
drive track.
Adjusting the drive track alignment and de-
flection (RX10P / RX10PS)
1.
Loosen the rear axle nut.
72
1. Rear axle nut
2.
Lift the rear of the snowmobile onto a suit-
able stand to raise the drive track off the
ground.
3.
Start the engine and rotate the drive track
one or two turns. Stop the engine.
4.
Loosen the locknut on the left and the
2
right sides of the snowmobile, then align
the drive track by turning the adjusting
bolt on each side.
Drive track
alignment
Left adjusting
bolt
Right adjust-
ing bolt
1
3
1. Left adjusting bolt
2. Right adjusting bolt
3. Locknut
Shifted to
Shifted to left
right
Turn out
Turn in
Turn in
Turn out
1
3
2
Advertisement
Table of Contents
