Table of Contents
Advertisement
Periodic maintenance and adjustment
1
1. Slot
2. Projection
14. Fit the weatherstrip on the headlight unit
into the recess in the top of the air filter
case cover.
1
1. Weatherstrip
15. Install the headlight unit bolts, and then
tighten them to the specified torque.
Tightening torque:
Headlight unit bolt:
3.0 Nm (0.30 m·kgf, 2.2 ft·lbf)
16. Install the top cover, the left and right side
covers, and the shroud.
ESU12270
Adjusting the headlight beams
1.
Remove the top cover. (See page 50 for
removal procedures.)
2.
Use a Phillips screwdriver to turn the
headlight beam adjusting screw and ad-
just the headlight beams. To lower the
headlight beams, turn the headlight
78
2
beam adjusting screw in direction (a). To
raise the headlight beams, turn the head-
light beam adjusting screw in direction
(b).
(b)
1
1. Headlight beam adjusting screw
3.
Install the top cover.
ESU12290
Fittings and fasteners
Check the tightness of the fittings and fasten-
ers.
Tighten in proper sequence and torque if nec-
essary.
ESU14020
Battery
The battery is located under the air filter case.
(See page 79.)
This model is equipped with a VRLA (Valve
Regulated Lead Acid) battery. There is no
need to check the electrolyte or to add distilled
water. However, the battery lead connections
need to be checked and, if necessary, tight-
ened.
EWS00540
WARNING
Battery electrolyte is poisonous and dan-
gerous. It contains sulfuric acid and can
cause severe burns. Avoid contact with
skin, eyes, or clothing.
ANTIDOTE:
EXTERNAL: Flush with water.
G
(a)
Advertisement
Table of Contents
