Dismount The Start Number Plate; Fitting The Start Number Plate; Handlebar Position; Adjusting Handlebar Position - KTM 450 SXS-F Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE

Dismount the start number plate

Fitting the start number plate

Handlebar position

A A A 0 0 A

Adjusting handlebar position

1 0 0 1
2 0 0 2
Remove screw
Remove screw
500123-10
Check parts for damage and wear. Replace damaged or worn parts.
Position the start number plate. Mount and tighten screw
Specification
Remaining screws, chassis
Info
Take care with the contact of the holding lug at the fender.
Position brake line. Put the clamp on, mount and tighten screw
500123-11
On the upper triple clamp, there are 3 holes on each side at a distance of
other.
Distance
The holes on the handlebar support are placed at a distance of
Distance
B B
The handlebar can be mounted in 6 different positions. This enables you to mount the
handlebar in the position most suitable for the rider.
200384-01
x
Remove the four screws
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
Remove the two screws
Place the handlebar support in the required position. Fit and tighten the two
screws
200384-02
Specification
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
and take off clamp.
. Remove the start number plate.
between holes 14 mm (0.55 in)
between holes 3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar
. Remove the handlebar support.
.
M10
.
M6 10 Nm (7.4 lbf ft)
.
from the center.
®
40 Nm Loctite
(29.5 lbf ft)
34
to each
243™