MAINTENANCE ON CHASSIS AND ENGINE
Greasing the steering head bearing
Remove the lower triple clamp.
Install the lower triple clamp.
Dismounting the front fender
Installing the front fender
Position the upper triple clamp with the steering.
Mount and tighten nut
Specification
Nut, upper steering head
Hold nut
Specification
Screw, top steering head
200391-10
Position the clutch line, wiring harness and CDI control unit. Mount and tighten
screws
.
Specification
Remaining screws, chassis
Install front fender. (
Fit the start number plate. (
Install the fork legs.
Mount and tighten screw
Specification
Screw, top steering stem
Check the cable harness, cable, brake and clutch line for free movement and rout-
ing.
Check play of steering head bearing. (
200368-12
x
x
(
P. 32)
x
(
P. 32)
Remove screws
Make sure that the distance bushings remain in place.
500092-10
Check parts for damage and wear. Replace damaged or worn parts.
Make sure that the spacing sleeves are mounted in the fender.
Position the front fender. Mount and tighten screws
Specification
Remaining screws, chassis
Info
Take care with the contact of the holding lugs to the start number plate.
500092-10
.
and tighten screw
.
P. 33)
P. 34)
x
(
P. 31)
.
M8
. Remove the front fender.
M20x1
15 Nm
(11.1 lbf ft)
M20x1
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
17 Nm
Loctite
(12.5 lbf ft)
P. 28)
.
M6
10 Nm (7.4 lbf ft)
33
®
243™