Topping Up The Front Brake Fluid; Checking The Front Brake Linings - KTM 450 SXS-F Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE

Topping up the front brake fluid

Warning
Danger of accidents Brake system failure.
MINIf the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.
Warning
Skin irritations Brake fluid can cause skin irritation on contact.
Avoid contact with skin and eyes, and keep out of the reach of children.
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking due to old brake fluid.
Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.
Warning
Environmental hazard Problem materials cause environmental damage.
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
KTM recommends DOT 5.1 brake fluid from Motorex
greater safety for high demands.
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!

Checking the front brake linings

Warning
Danger of accidents Reduced braking due to worn brake linings.
Worn brake linings should be replaced immediately in an authorized KTM workshop.
x
®
. This has a higher wet boiling point than DOT 4 brake fluid and provides
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
Remove screws
Remove the cover
Top up brake fluid to level
Specification
Measurement of
Brake fluid DOT 5.1 (
Check parts for damage and wear. Replace damaged or worn parts.
Position the cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
400230-10
.
with membrane .
.
5 mm (0.2 in)
P. 82)
42