Emptying The Carburetor Float Chamber - KTM 450 SXS-F Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE

Emptying the carburetor float chamber

Danger
Fire hazard Fuel can easily catch fire.
Never fill up the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See specifications on filling up with fuel.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
Do not allow fuel to get into the ground water, the ground, or the sewage system.
Info
Carry out this work with a cold engine.
Adjust to the point between these two positions with the highest idle speed.
Info
If there is a big engine speed rise, reduce the idle speed to a normal level
and repeat the above steps.
The extreme sport motocyclist will set the mixture about 1/4 of a turn back
from this ideal value (leaner, in a clockwise direction) since the engine
becomes hotter in sporting use.
If the procedure described here does not lead to satisfactory results, the
cause may be a wrongly dimensioned idling jet.
If you can turn the idle adjusting screw to the end without any change of
engine speed, you have to fit a smaller idling jet.
The idle adjusting screw must not be opened more than two turns. If more
than two turns are necessary (rich mixture), use a larger idling jet.
After changing the idling jet, start from the beginning with the adjusting
steps.
Adjust the idle speed with the adjusting screw
Specification
Choke function activated
Idle speed
Info
Following extreme air temperature or altitude changes, adjust the idle speed
again.
x
Turn the handle
No more fuel flows from the tank to the carburetor.
Guide the hose coming down behind the engine into a suitable container.
Info
Water in the float chamber results in malfunctioning.
Undo the screw
the float chamber.
Tighten screw
200382-11
The choke lever is pushed in to the stop. (
1,600... 1,650 rpm
of the fuel tap to the OFF position. (Figure 500178-10
(turn it counterclockwise) a few turns and drain the fuel from
.
.
P. 11)
P. 11)
64