Table of Contents
Advertisement
Steps for loading incremental patches
Step
Action
1.
Load the incremental tape on the
selected peripheral device. The
system should be at logon level 3
or higher.
2.
Enter COP TAP ALL and press
<ENTER>.
3.
Enter @V3AINC and press
<ENTER>.
4.
Enter Y or N. Answering Y indicates
that the patches were loaded
successfully.
If you answer N, you may need to
complete the procedure again.
XEROX 4635 LASER PRINTING SYSTEM—SYSTEM GENERATION GUIDE
SYSGEN AND SYSGEN-RELATED PROCEDURES
System response
OS1000 Ready For Commands
Creating or replacing of files takes place followed by:
**_End of tape read
OS1000 Ready For Commands
The patches are applied, and the system displays:
PCH (patch name)
** Processing the file . . .**
*** START of (version) SST Incremental Patches ****
**** END of (version) SST Incremental Patches ********
DID THE PATCHES APPLY WITHOUT ANY ERRORS? (Y/N)
The system deletes the files applied by the incremental
tape and displays:
SYSTEM WILL ROLLOVER IN 1 SEC
The system initializes and displays:
OS1000 - Ready For Commands
hh:mm:ss
hh:mm:ss
hh:mm:ss
4-35
Advertisement
Table of Contents
