Table of Contents
Advertisement
SYSGEN AND SYSGEN-RELATED PROCEDURES
Steps to perform an online update sysgen (continued)
Step
Action
3.
PC UI:
Select System Disk from the Boot
menu.
Terminal:
Enter BD and press <ENTER>.
Note: This step assumes that a
version of the operating system
already resides on the disks. If this
is not the case, you must load a version
of the sysgen processor from tape
(by entering BT) and perform a full
or update sysgen.
4.
Enter SYSGEN and press <ENTER>.
5.
Enter N to retain the existing ID or Y
to enter a new system ID and press
<ENTER>.
6.
Enter Y or N and press <ENTER>.
7.
Enter Y or N and <ENTER>. A Y
and <ENTER> response causes the
change menu to display. Each time a
change is made, the change question
is asked until an N and <ENTER> is
entered, and the sysgen program
continues.
4-24
System response
The command menu displays:
COMMANDS
Display commands
BOOT
Boot the operating system
SYSGEN
Build or update system files on disk from
tape or host
FORMAT
Format and initialize disk pack
HOSTCOPY
Copy user files from host to disk
AUTO
Auto Sysgen
MINI
Configuration change only
ERASE
Erase all files.
This starts the current processor sysgen procedure and
the following message displays:
* Sysgen program running *
System ID is: xxxxx
Do you want to enter a new system id? 'y' or 'n'
Do you want to save the accounting file? enter 'y' or
'n'
The base configuration and the system configuration
options are displayed followed by:
Do you wish to make any changes? Enter 'y' or 'n'
>
Do you want to discard the changes you just made? Enter
'y' or 'n''
>
XEROX 4635 LASER PRINTING SYSTEM—SYSTEM GENERATION GUIDE
Advertisement
Table of Contents
