Table of Contents
Advertisement
SYSGEN AND SYSGEN-RELATED PROCEDURES
Steps to perform a full sysgen (continued)
Step
Action
6.
Enter Y to confirm that you want to
continue the formatting of the disk(s).
NOTE: DP1: through DP3: will only
be displayed if installed.
7.
Enter the option number and press
<ENTER>.
Option 1 selects all disk drives
installed on the controller.
Option 2 allows individual drives
to be selected.
Enter the drive unit number to
be formatted. If more than one drive
unit is to be formatted, enter all
selected drive unit numbers
separated by commas.
Such as: >0,1,3
Then press <ENTER>.
4-6
System response
For Y, the following is displayed:
**SCSI FORMAT/ERASE VERSION XX RUNNING**
Program operating mode: FORMAT
Located DP0: ...(manufacturer) (disk type)
Located DP1: ...(manufacturer) (disk type)
Located DP2: ...(manufacturer) (disk type)
Located DP3: ...(manufacturer) (disk type)
FORMAT OPTIONS:
1. All disks
2. Selected disk(s)
>
Enter the disk units to format
>
DP0: CONFIRM (Y/N)
The following information is displayed for the disks
selected to be formatted:
Disk characteristics (DPx:)
Manufacturer & Type: (manufacturer) (disk type)
Unit Serial Number: nnnnn
Usable capacity: cccc MB
Number of 512-byte sectors: ssssss
Number of heads: h
Number of tracks: ttttt
Spare sectors per cylinder: s
Spare tracks per device: tt
XEROX 4635 LASER PRINTING SYSTEM—SYSTEM GENERATION GUIDE
Advertisement
Table of Contents
