Table of Contents
Advertisement
SYSGEN CONFIGURATION OPTIONS
Option
13) Raster image
processor (if
installed)
14) Terminal type
15) Tape device table
16) Default printing order
3-6
Description
Displays the following question:
DOES THIS SYSTEM HAVE A RASTER IMAGE PROCESSOR? ENTER 'Y' OR 'N'
If you enter N, all raster image processor (RIP) devices are removed from the
system.
If you enter Y, the following message is displayed:
TYPE THE RIP UNIT NUMBERS (0-3)
ENTER OPTIONS
Enter the appropriate numbers. If found, they are added to the system. If
RIP is not found, the following message display:
RIP x IS NOT IN THE SYSTEM (PLEASE CONFIRM)
ENTER 'Y' OR 'N'
Selecting this option changes the terminal to a PC type; selecting it again
changes it to a character type. Note: The character type terminal is not
supported.
Selecting this option allows you to alter the tape device assignment table.
Selecting this option displays the following suboptions:
1) 1 - N
2) N - 1
Enter option 1 for first-to-last page (facedown) output; or option 2 for last-
to-first page (faceup) output.
You may select either 1TON or NTO1 as the system default.
When the system default is 1TON, NTO1 is processed only if it is invoked in
the JDE or JDL. The system ignores NTO1 in DJDE-selected job descriptor
entries (JDEs) or job descriptor libraries (JDLs).
When the system default is NTO1, the system assumes each report is NTO1
until the first data page, even if 1TON is specified in the JDE or JDL. This
arrangement allows you to use DJDE-selected JDEs and JDLs that invoke
NTO1 after a series of banner pages.
XEROX 4635 LASER PRINTING SYSTEM — SYSTEM GENERATION GUIDE
Advertisement
Table of Contents
