Getting Started; Batteries; Change Settings; Remote Sensor - Oregon Scientific RAR601 User Manual

GETTING STARTED

BATTERIES

Batteries are not supplied with this product. You will need
to purchase 2 x UM-4 (AAA) 1.5V alkaline batteries for
the main unit, and 2 x UM-3 (AA) 1.5V alkaline batteries
for the remote sensor.
Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
Do not use rechargeable batteries.
NOTE
shows when batteries are low.
UNIT
Main
Remote
RAR601 lab test R2
LOCATION
Indoor Temperature Area
Outdoor Temperature Area.
6
6

CHANGE SETTINGS

1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press UP or DOWN to change settings.
3. Press MODE to confirm.

TABLE STAND OR WALL MOUNT

Insert the stand on the back of the product, or mount it
on a wall with a nail.

REMOTE SENSOR

This product is shipped with a Sensor that collects
temperature readings. Only one sensor can be used with
this product.
1/17/04, 4:47 PM