Table of Contents
Advertisement
5 A
M
D
L
COUSTIC
EASUREMENT FOR
IRAC
IVE
The Dirac Live Calibration Tool Stereo for miniDSP uses a set of measurements made in your listening room to
calculate correction filters for the left and right channels. The measurements are made using the DDRC-24
processor and a miniDSP UMIK-1 measurement microphone.
5.1 L
OUDSPEAKER AND MICROPHONE POSITIONING
Prior to performing acoustic measurements, optimize your loudspeaker and listening positions. Start with the
recommendations of the manufacturer of your loudspeakers. Loudspeakers designed for home hifi use typically
perform best away from the walls, whereas speakers designed for studio use may be designed for use closer to
walls or other surfaces. With Dirac Live®, you have more freedom with loudspeaker placement but the best
result will still be achieved if optimal loudspeaker placement is used together with Dirac Live®.
You should also experiment with toe-in – many loudspeakers benefit from pointing directly at the listening
position or even slightly in front. The listening position should be away from the rear wall, as placing the
listening chair or sofa right against the wall will result in increased early reflections and changes in timbre.
A total of nine measurements must be taken, with the microphone located in different positions in the room
and pointed between the two speakers. The first measurement must be taken at the central location of the
listening area, as this location sets the levels and delays of each speaker. Usually, this location will be an equal
distance from both speakers but it is not necessary – Dirac Live® will adjust if it is not. Eight more measurements
are then taken at locations spread around the listening area and at different heights from the floor.
27
miniDSP Ltd, Hong Kong /
www.minidsp.com
/ Features and specifications subject to change without prior notice
Advertisement
Table of Contents
