Adjusting The Transport Speed - Toro 04520 Operator's Manual

Note: If the wheel still turns when the eccentric
is at the maximum adjustment, contact your
Authorized Service Distributor or refer to the
Service Manual for further adjustment.

Adjusting the Transport Speed

Obtaining the Maximum Transport
Speed
The traction pedal is adjusted for maximum-transport speed
at the factory, but you may need to adjust it if the pedal
reaches full stroke before it contacts the pedal stop, or if you
want to a decrease the transport speed.
To obtain the maximum-transport speed, put the functional
control lever in the T
RANSPORT
the traction pedal. If the pedal contacts the stop
before you feel tension on the cable, perform the following
adjustment procedure:
1
1. Pedal stop
1. Put the functional-control lever in the T
position and loosen the locknut securing the pedal stop
to the floor plate (Figure
2. Tighten the pedal stop until it does not contact the
traction pedal.
3. Continue applying a light load on the transport pedal
and adjust the pedal stop so it contacts the pedal rod
and tighten the nuts.
Important: Ensure that the tension on the cable
is not excessive or you will reduce the cable life.
Reducing the Transport Speed
1. Press down on the traction pedal and loosen the
locknut securing the pedal stop to the floor plate.
position and press down on
(Figure
Figure 47
RANSPORT
47).
2. Loosen the pedal stop until you obtain the desired
transport speed.
3. Tighten the locknut securing the pedal stop.
47)
g015494
40