Hour Meter; Ignition Switch - Toro 04520 Operator's Manual

Figure 12
1. Throttle lever
2. Raise/Lower mow control
3. Functional-control lever

4. Ignition switch

5. Engine-oil-pressure light
Raise/Lower Mow Control
Moving the control (Figure
lowers the cutting units and starts the reels. Pull back on the
control to stop the reels and raise the cutting units. During
operation the reels can be stopped by pulling back on the
control momentarily and releasing it. Start the reels by
moving the control forward.
Functional Control Lever
The functional control lever
selections plus a N
EUTRAL
from mow to transport or transport to mow (not to neutral)
while the machine is in motion. No damage will result.
•
R Position—neutral and backlapping
EAR
•
M Position—used for mowing operation
IDDLE
•
F Position—used for transport operation
RONT
Ignition Switch
Insert the key into the switch
as far as possible to the S
TART
Release the key as soon as the engine starts; the key will move
to the O position. Turn the key counterclockwise to the
N
O position to stop the engine.
FF
Battery-Warning Light
The light (Figure 12) glows if the battery charge is low.
6. Battery-warning light
7. Service-indicator light
8. Glow-plug-indicator light
9. Water-temperature light
12) forward during operation
(Figure 12) provides 2 traction
position. It is permissible to shift
(Figure 12) and turn it clockwise
position to start the engine.
Engine-Oil-Pressure Light
The light (Figure 12) glows if the engine oil pressure drops
below a safe level.
Water-Temperature Light
The light (Figure 12) glows and the engine automatically shuts
down when the engine-coolant temperature gets too high. If
the engine shuts down, you can start the engine and drive
the machine for 10 seconds before it will shutdown again,
allowing you to move the machine to a location where you
can allow it to cool down.
Service-Indicator Light
The service-indicator light
machine sensors detect an issue with one of the systems
of the machine. If this light illuminates, stop what you are
doing and drive to a safe location where you or a service
technician can diagnose the problem. For more information
on diagnosing system issues using the service-indicator light,
refer to Diagnosing the Service Indicator Light (page
Glow-Plug-Indicator Light
When the glow-plug-indicator light
indicates the glow plugs are on.
Note: The glow-plug-indicator light may illuminate for a
short time after the engine has started; this is normal.

Hour Meter

The hour meter (Figure
machine has operated. It starts to function whenever you
rotate the ignition switch to the O
1. Hour meter
17
(Figure 12) illuminates when the
(Figure 12) is lit, it
13) indicates the total hours the
position.
N
g014600
Figure 13
45).
1