Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
Media and Additional Parts
Description
Operator's Manual (machine)
Engine operator's manual (engine)
Parts Catalog
Operator training materials
Pre-delivery Inspection Sheet
Noise rating certificate
Certificate of compliance
Ignition keys
Description
Roll bar
Bolt (1/2 x 3-3/4 inches)
Flange-nut (1/2 inch)
Seat-completion kit
Steering wheel
Locknut (1-1/2 inches)
Washer
Steering-wheel cap
No parts required
No parts required
Grass-basket hook
Flange bolts
Gauge bar
Cutting unit (obtain from your Toro
Distributor)
Grass basket
Weight Kit, 121-6665 (purchase
separately) Note: This kit is not required
for units with the 3 wheel drive kit
installed.
Warning decal, 133-2338
No parts required
No parts required
Qty.
1
4
4
1
1
1
1
1
–
–
6
12
1
3
3
1
1
–
–
Qty.
1
Read before operating the machine
1
1
Save for future parts ordering
1
View before operating the machine
1
1
Save for future reference
1
2
Start the engine
11
Use
Install the roll bar.
Install the seat to the base.
Install the steering wheel.
Activate and charge the battery.
Install the optional oil cooler.
Install the grass-basket hooks.
Install the cutting units.
Add rear weight.
Install EU decals, if required.
Reduce the tire pressure.
Burnish the brakes.
Use