7
Installing the Cutting Units
Parts needed for this procedure:
1
Gauge bar
3
Cutting unit (obtain from your Toro Distributor)
3
Grass basket
Procedure
1. Setup the cutting units as described in the cutting unit
Operator's Manual.
2. Apply grease to the inside diameter of the drive coupler.
3. Install the cutting units as described in
Cutting Units (page
8
Adding Rear Weight
Parts needed for this procedure:
Weight Kit, 121-6665 (purchase separately) Note:
1
This kit is not required for units with the 3 wheel drive
kit installed.
Procedure
This unit complies with EN ISO 5395:2013 and ANSI
B71.4-2012 when equipped with Weight Kit, Part No.
121-6665.
Note: If the unit is equipped with a 3-Wheel Drive Kit,
additional weight is not required to meet EN ISO 5395:2013
and ANSI B71.4-2012.
9
Installing EU Decals
Parts needed for this procedure:
1
Warning decal, 133-2338
Procedure
If this machine will be used in the EU, affix the warning-decal
133-2338 over English warning-decal 133-2339.
Installing the
27).
10
Reducing the Tire Pressure
No Parts Required
Procedure
The tires are over-inflated at the factory for shipping
purposes. Reduce the pressure to the proper levels before
starting the machine. Refer to
(page
25).
11
Burnishing the Brakes
No Parts Required
Procedure
Firmly apply the brakes and drive the machine at mowing
speed until the brakes are hot, as indicated by their smell. You
may need to adjust the brakes after the break-in period; refer
to
Adjusting the Brakes (page
15
Checking the Tire Pressure
42).