Jump-Starting The Machine; Drive System Maintenance; Adjusting The Transmission For Neutral - Toro 04520 Operator's Manual

Jump-Starting the Machine

If you need to jump start the machine, you can use the
alternate-positive post (located on the starter solenoid) instead
of the positive battery post
Figure 45
1. Alternate-positive post
(Figure 45).
Drive System
Maintenance
Adjusting the Transmission
for Neutral
If the machine creeps when the traction-control pedal is in
the N position, adjust the neutral-return mechanism.
EUTRAL
1. Block up under the frame so that one of the front
wheels is off of the floor.
Note: If machine is equipped with a 3-Wheel Drive
Kit, also raise and block rear wheel.
2. Start the engine, move the throttle to the S
position, and ensure that the front wheel that is off
of the floor is not rotating.
3. If the wheel is rotating, shut off the engine and proceed
as follows:
A. Loosen the nut securing the eccentric to the top
of the hydrostat
1
1. Eccentric
B. Move the functional-control lever to the N
position and the throttle to the S
Start the engine.
C. Rotate the eccentric until creep does not occur in
either direction. When the wheel stops rotating,
tighten the nut locking the eccentric and the
adjustment
with the throttle in the S
39
(Figure 46).
Figure 46
2. Locknut
LOW
(Figure 46). Verify the adjustment
and F
LOW AST
LOW
2
g014616
EUTRAL
position.
position.