Table of Contents
Advertisement
4 Press the START key
until the display shows
--->.
5 Press the </> keys to
show the other values
available: "01, 04, 08".
(In the example: "04").
6 Press the START key
to confirm your
selection and then the
STOP key to restore
the fax initial waiting
mode.
To change ringing volume ...
You can also change the ringing volume as follows:
Procedure
1 Make sure that the
display shows the initial
waiting mode with date
and time.
2 Press the FUNCTION
key until the display
shows --->.
3 Press the START key.
4 Press the FUNCTION
key.
5 Press the START key
until the display shows
--->.
6 Press the </> keys to
show the other options
available: "RING
VOLUME: LOW",
"RING VOLUME: OFF",
"RING VOLUME: MED".
(In the example: "RING
VOLUME: LOW").
7 Press the START key
to confirm your
selection and then the
STOP key to restore
the fax initial waiting
mode.
48
-7-46-54.p65
RING COUNT: 02
RING COUNT: 04
PHONE/FAX RX
30-03-99
12:55
DISPLAY
PHONE/FAX RX
30-03-99
12:55
FAX SET-UP
DATE AND TIME
VARIOUS SETTINGS
RING VOLUME: HIGH
RING VOLUME: LOW
PHONE/FAX RX
30-03-99
12:55
48
Recognising the ringing pattern...
In some countries, local telephone network managers
offer the possibility of assigning two or more telephone
numbers to the same phone line corresponding to differ-
ent users. At each call, different ringing patterns will indi-
cate which user is to reply.
This function is very useful in domestic or small office
environments, where the same telephone line is shared
beween several people.
Your fax machine is capable of accepting one of
these patterns (see the following table). In "FAX/TEL
RX" and "TAD/FAX RX" reception modes, the fax ma-
chine, when receiving a call with that specific dial tone,
always prepares itself to receive a document.
If the ringing pattern is not recognised, the fax ma-
chine will behave as already described in "Automatic
reception with call type recognition" and "Receiv-
ing with an answering machine" chapter "For every
day use".
This function is particularly recommended is associ-
ated to silent reception since the fax machine will only
ring in the case of a telphone call.
For further information concerning access to this serv-
ice, contact the telephone network manager.
For models with internal answering machine, it is ad-
visable to disconnect the answering machine before
activating the recognition procedure.
Procedure
1 Make sure that the
display shows the initial
waiting mode with date
and time.
2 Press the FUNCTION
key until the display
shows --->.
3 Press the START key.
4 Press the START key
until the display shows
--->.
5 Press the </> keys until
the display shows --->
6 Press the START key
to confirm your
selection.
02/04/01, 9.22
DISPLAY
PHONE/FAX RX
30-03-99
12:55
INSTALLATION
TEL. LINE SET-UP
DISTINC. RING: OFF
CHANGE PATTERN
AUTODETECT. RING
Advertisement
Table of Contents
