Misc - EverFocus PARAGON 264x4-16 Instruction Manual

RS485
PTZ Protocol: Select PTZ protocol Choose from the following protocols: Transparent, Pelco D, Pelco P,
Everfocus, or Samsung. (NOTE: all cameras must be on the same protocol)
485 ID: RS-485 address, addressable between 0 and 127. This address is equivalent to the device number
if remote control is effected through the RS-485 keyboard EKB 500 (DEVICE No.).
Baud Rate: The speed used to transmit instruction or information through the RS485 port on the DVR.
Choose from the following speeds: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 BPS.
Data Bit: The data bit used for transferring. This can be set to 8 or 7.
Stop Bit: This field is to set the stop bit for the RS485 connection. This can be set to 1 or 2.
Parity: This selects the transmission level of the connection. Choose either None, Odd, or Even.
Control
IR Remote ID: ID used by the remote control. This can be set from 1 to 4.

5.10.5 Misc.

Firmware
Current Firmware Version: Displays the current version.
Firmware Upgrade: Press "Upgrade" to upgrade the firmware.
NOTE: To perform a Firmware Upgrade, you will need to connect a USB flash device with
the latest version of the firmware. Do not disconnect USB device or turn off the power of
the unit during the upgrade; this can cause the system to crash.
Figure 5-44 System Menu – Firmware & Misc.
90