Alarm & Event Setting; Alarm - EverFocus PARAGON 264x4-16 Instruction Manual

5.5 ALARM & EVENT SETTING
is a screen shot of the ALARM & EVENT SETTING MENU. This menu will walk you through
Figure 5-11
alarm and event setup.

5.5.1 Alarm

Alarm: Select the alarm number from 1 to 16.
Enable: Check box to enable alarm.
Log: Check box to record alarm events in the log.
Pre-alarm Record: Check the box to record several moments (approx. 2 ~ 10 seconds) before the alarm
event. The pre-alarm recording rate follows the "Normal" frame rate setting (Camera Menu).
Buzzer: Check box to enable buzzer when an alarm occurs.
Email Notify: Check box to enable email notification when an alarm occurs.
Network Alarm: Check box to send out a network alarm to client PC when an alarm event occurs. (This
function requires the optional PowerCon 4.x network management software as well as setting up the alarm
server in the Network Setup menu)
Auto Lock: Check the box and the events will be recorded in the write protected segment of the Hard Disk.
(DVR will lock a period of time when an alarm happens; the length of time depends on the DVR settings)
Alarm Output: This will transmit a signal through one of the alarm outputs. It can be set to either "NONE"
(not active), "1", "2", "3", or "4".
Output Type: Output action when alarm is triggered.
Timeout: Alarm output lasts for the set time duration.
Permanent: Alarm will remain active until user presses "Enter" key.
Figure 5-11 Alarm & Event Menu - Alarm
53