Connection To Several Dvrs; Speed Dome Installation; Connection; Usb-Mouse Installation - EverFocus PARAGON 264x4-16 Instruction Manual

2.4.4 EKB-500 connection to several DVRs
For long distance installations connecting several DVRs, please use signal distributor to connect
For further details on keyboard connection, please refer to the EKB-500 manual.
RS-485 port communication settings are configured in the I/O CONTROL menu (
Verweisquelle konnte nicht gefunden werden. System Setup: I/O - control).

2.4.5 Speed Dome Installation

Speed dome or telemetry receiver pan/tilt/zoom control is available through web browser or the optional
PowerCon software if the DVR is connected to a network. Local telemetry control is provided by USB -
mouse control or by the optional EKB-500 keyboard.
Supported protocols: EverFocus, Pelco-D, Pelco-P, Samsung, Transparent
Required DVR settings: RS-485 receiver address in CAMERA menu
ATTENTION: Some Pelco-D / -P protocol domes and receivers require an address offset of -1, i.e. the
address assigned to the dome / receiver in the DVR camera menu must be 1 below the address set in the
dome / receiver itself!
2.5 RS-232 Connection
1 2 3 4 5
6 7 8
9

2.6 USB-Mouse installation

Connect the USB mouse to one of the 2 USB ports. (This can be done while DVR is powered on)
NOTE: Recommended mouse types are Logitech® and Microsoft® wired USB wheel-mouse. Wireless
USB mouse is not supported.
( chapter Fehler! Verweisquelle konnte nicht gefunden werden..)
RS-485 parameters and protocol in the I/O CONTROL menu
( chapter Fehler! Verweisquelle konnte nicht gefunden werden..)
Pin
2
3
5
Function
TXD
RXD
Ground
15
chapter Fehler!